Mapecem Quickpatch is a high-performance, fast-setting, cementitious material used for the patching of concrete surfaces. This product features a very low emission of volatile organic compounds and includes an offset of greenhouse gas emissions.
Mapei
Mapecem Quickpatch – High-Performance Concrete Patch
$15.99
SKU: 49
Category: Mapei
Tags: Cement-Based, Concrete Patching Compound, Fast-Drying, Patching Compound
Description
High-performance concrete patch, with CO2 fully offset in the entire life cycle
Mapecem Quickpatch is a high-performance, fast-setting, cementitious material used for the patching of concrete surfaces. This product features a very low emission of volatile organic compounds and includes an offset of greenhouse gas emissions.
- Natural gray to blend with existing concrete
- Ease of placement, with variable water ratios
- Can be applied from 1/16″ to 1-1/2″ (1.5 mm to 3.8 cm) neat and from 1-1/2″ to 3″ (3.8 to 7.5 cm) neat in areas no larger than 24 sq. ft. (2.23 m²). Larger areas will require Mapecem Quickpatch to be extended.
- Can be primed and covered with a leveler, a cement-based overlay or a tile-setting mortar in as little as 90 minutes, depending on temperatures.
- Moisture-controlling adhesives or moisture mitigation systems can be used over this product in as little as 16 hours.
- Floor coverings can be installed in as little as 16 hours after application as long as the existing subfloor meets the requirements of the mortars or adhesives used for installation.
Where to Use Mapecem Quickpatch
- For patching of interior/exterior concrete surfaces
- For smoothing, including elevation changes by ramping
SUITABLE SUBSTRATES
- Concrete at least 28 days old
Consult MAPEI’s Technical Services Department for installation recommendations regarding substrates and conditions not listed.
CURING
- self-curing; do not use a damp-curing method.
LIMITATIONS
- Do not install over substrates containing asbestos.
- Do not apply over standing water.
- Do not use as a crack filler.
- Do not add cement or chemical admixtures other than diluted Planicrete UA.
- Mapecem Quickpatch can be applied from 45°F to 85°F (7°C to 29°C). Allow for extra curing time for temperatures below 70°F (21°C).
- Honor all joints through Mapecem Quickpatch.
- Do not apply if rain or freezing temperatures are expected within 24 hours.
- Do not expose to rolling loads for at least 24 hours after installation.
Additional information
Weight | 27 lbs |
---|
Related products
-
Mapei
Mapei Aqua Plus Crack Filler
$57.00 -
Mapei
Ultrabond ECO 575 – Wall Base Adhesive
$9.99